Call us to get tree service including tree cutting, tree fell, bush trim, shrub dig, stump felling and lots more within USA:


Click to call

Call now +1 (855) 280-15-30






If you are unable to remove it your last resort could always call your.

Use a chainsaw or limbing saw to remove any lower branches from the trunk. Remove the top portion of the trunk, but leave enough to use as leverage. Use a shovel, pick mattock and digging bar as needed to reveal the roots around the stump. Use a hose or power washer to rinse dirt away to reveal more shrublop.buzzg: Rockland MA. You will need to invest in the right equipment. This project will call for a shovel or garden mattock, a chain saw, a drill, a wheelbarrow and a gas-powered stump grinder.

stump grinding in Rockland, MA. stump grinding in Rockland, MA. The grinder will automatically set you back a couple of thousands of dollars. Aug 31, Use a chain saw or bow saw to cut the stump down as close to the ground as you can, without allowing the chain saw's teeth to strike the ground (this will dull your chain).

Likewise, small stumps are also easier to remove than large ones.

Wear steel-toed boots for this part of the job. Drill holes a few inches deep into the stump in numerous places, using the biggest, widest drill bit you shrublop.buzzg: Rockland MA. Drill Holes in the Stump. Cut off as much of the top of the stump as possible with your chainsaw. Use a 1-inch spade bit with a spade bit extension to drill evenly spaced holes roughly every 6 to 8 inches around the perimeter of the stump. Make the holes about 12 inches deep and three to Estimated Reading Time: 3 mins.

Start by trimming the stump closer to the ground with a chainsaw. Dig up any rocks around the base of the stump. Hard debris can damage the blades of the stump grinder. Keep the equipment in good working order. Dull blades and missing teeth can be an obstacle to removing the stump.

Sharpen and replace these parts as shrublop.buzzg: Rockland MA.